10 Apps To Aid You Manage Your Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 might be catching on a bit, but it still feels attractive. It's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid whether the issue is ongoing or intermittent.
Water Damage
If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking canoeing, rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry container whenever you go outdoors or do things that expose it to excessive amounts water.
You should also make sure that the fob is completely dry prior to opening it and re-using it. If you detect any odors from the fob (such as industrial liquid or windshield washer fluid) This is a further indication that it's been submerged.
A circuit board that's damp can cause the battery to discharge its charge, or even explode. If you can get your keyfob 308 out of the water you need to turn the button side up and shake as much water as possible before opening the casing. After you open it, take out the battery and wipe down the circuit board using the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system may not function include a dead coin cell battery or receiver module malfunction signal interference, or a defective chip. If none of these are the problem you can reset the system by disconnecting the 12 volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to stepping inside. This feature is extremely beneficial particularly during the winter's cold and chilly months. Remote start systems can cease to function for a variety reasons, including a dead coin-battery.
A coin-shaped battery located inside the key fob can last for a period of between two and four years, based on how often it is used and the location where it was purchased. The date of use is usually written on the package or in the manual.
If the key fob stopped functioning after exposure to clean tap water it is recommended to remove the battery, clean the chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. If you expose it to soapy or salty water, the chip could be damaged and you'll require replacing the key fob altogether.
If you're not sure the battery is defective you can check its voltage using a multimeter that is set to the car's voltage range. Connect it to the terminals for minus and plus. If the voltage is less than 12-13 volts then you need to replace the battery. You can also try to reset the on-board computer by disconnecting the battery at 12 volts for a few minutes and reconnecting it in reverse order (positive cable first, then negative). The engine should now start.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, it's possible the receiver module has developed a fault. It's the part that sends out the signal when your key fob turns on. It also functions as an alarm that stops the car from starting if it doesn't have the correct key.
This could be due to a range of causes, such as water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, as in the electronic chip located inside is damaged. In this situation, you'll have to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and try again.
If the issue continues to persist the issue persists, it's a good idea to seek out an area Peugeot specialist or locksmith. They'll be able use a diagnostic tool to identify the problem and repair it for you.
It is stressful to lose your Peugeot car key. However, a reputable auto locksmith can resolve the issue in a matter of minutes. They can cut a new key and programme it to your vehicle, so you're ready to get out on the road in the shortest time possible. Click here to locate the nearest locksmith.
Electronic chip malfunctions
The electronic chip inside the Peugeot 308 key fob is a critical function in the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or get a message saying "anti-theft". If this happens, the only way to fix the issue is to replace the key. Fortunately, professional auto locksmiths can complete the task in the shortest amount of time.
The chip in your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob has been exposed to soapy water, you must cleanse it immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. The battery must then be allowed to completely dry.
Sometimes keys may not function due to radio interference. peugeot 207 new key programming can be caused when other devices use the same frequency as your Peugeot keyfob. It could be caused by problems with the environment or objects near to the vehicle. If you have this issue it is recommended to visit a Peugeot dealership.
The Peugeot 207/308 key fob is very delicate and requires extra attention. It is imperative not to drop or throw the key fob. If you lose it, try to locate it as quickly as is possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.